Set The 3300 Controller Ip Address - Mitel 3300 ICP Technician's Handbook

3300 ICP Technician's Handbook – Release 3.2
10. Reboot the system.
11. Set the 3300 Controller (RTC) IP address through a
communication program.
12. Install the other units as described in the System Installation
Overview.
13. As the final step, connect the 3300 Controller to the LAN.
Note: You may use the internal or an external DHCP Server.
The controller is shipped with the DHCP server Enabled. Use
DHCP reservations against the MAC address for the E2T.
Internal DHCP Server default settings - shipped enabled
TFTP Server
TFTP BootFile
IP Phone TFTP Server
MN330 (RTC) IP Address
Mitel IP Phone DHCP Server
Range

Set the 3300 Controller IP Address

To set the 3300 Controller IP address:
1. Establish a serial connection from the 3300 Configuration Tool
PC (or any PC equipped with a communications program) to
the Maintenance Port on the 3300 Controller.
2. Launch the communication program.
3. Set the RS-232 communication parameters:
Baud rate - 9600
Data bits - 8
Parity - None
Stop bits - 1
Flow control - None
4. Connect AC power to the 3300 Controller.
066 192.168.1.2
067 /sysro/E2T8260
128 192.168.1.2
129 192.168.1.2
130 MITEL IP PHONE
Start 192.168.1.20
End 192.168.1.24
- 18 -