Mitel 3300 ICP Technician's Handbook page 125

3300 ICP Technician's Handbook – Release 3.2
•
Install the Interface Assembly.
The CEPT DS1/T1 Formatter cards are installed in any empty DSU
slot. The DSU cabinet supplies the power for the card and provides
a message interface back to the control cabinet through the FIM
interface and the fiber optic cable.
To install the cards:
1. Attach the anti-static strap to your wrist.
2. Insert the card into the slot and close the locking latches.
Testing the Card
If the installation is successful, the card will boot up.
To test the card:
1. Inspect the LEDs on the faceplate to verify that the card is
functioning. See Faceplate LEDs.
2. In the System Administration Tool, Maintenance and
Diagnostics, use the STATE command to verify that the trunks
associated with the corresponding channels are all in IDLE
State.
PRI Installation Overview
The following section describes how to install the PRI card and PRI
interface assembly. You will need to program the PRI card into the
3300 ICP database to allocate links and trunks.
Install the PRI card in the following sequence:
•
Program the customer data in the 3300 ICP
•
Configure the card for Line Side or Trunk Side termination
•
Install the interface assembly
•
Install the PRI card
•
Configure the IMAT database
•
Connect the computer to the PRI card
•
Save the IMAT database onto the PRI card
•
Connect the PRI card to the ISDN network
- 117 -