Register Ip Telephones From The Station - Mitel 3300 ICP Technician's Handbook

3300 ICP Technician's Handbook – Release 3.2

Register IP Telephones from the Station

This procedure registers the IP devices with the 3300 ICP
database. The procedure will program the 3300 ICP database with
the MAC address of the IP device.
Before you begin
•
Ensure a Set Registration Access Code is assigned in the
System Options Assignment form.
•
Ensure the directory number and device type is
programmed in the Single Line IP Set Configuration form or
Multiline IP Set Configuration form.
To register IP telephones:
1. Connect the IP telephone to an RJ-45 Ethernet port on the
LAN.
2. Press * during power-up (to clear any PIN number in memory).
3. Type the PIN number at the prompt on the IP device. Prompts
- The 5001 IP Phone displays a solid message light.
- The 5005, 5010, 5020 IP telephones and the 5140 IP
Appliance show "Enter the PIN number" on the display.
4. Complete one of the following:
- Press Hold for the 5001 and 5005 IP Phones
- Press SuperKey for the 5010 and 5020 IP Phones
- Press OK for the 5140 IP Appliance
The set will complete initialization.
Note: Use the System Administration Tool to program all other
station features (for example, Class of Service, Interconnect
r†‡…vp‡v‚ÃTr‡ÃFr’Ã6††vt€r‡†ÃhqÃ8yh††Ã‚sà r†‡…vp‡v‚
When using the 3300 ICP in a cluster, the actual registering
sequence of the IP device is unchanged provided the following
guidelines have been observed:
•
The Cluster Element ID programmed in the Cluster Element
Assignment form must match the ICP/PBX Number
programmed in the ICP/PBX Assignment form.
- 126 -