Mitel 3300 ICP Technician's Handbook page 126

3300 ICP Technician's Handbook – Release 3.2
Install a PRI Card
The PRI card is installed in any empty DSU slot. The DSU cabinet
supplies the power for the card and provides a message interface
back to the control cabinet through the FIM interface and the fiber
optic cable.
To install the PRI card:
1. Attach the anti-static strap to your wrist.
2. Insert the PRI card into the slot and close the locking latches.
Connect PRI Card to the Network
To connect the PRI card to the network:
1. Unpack and inspect the ISDN PRI cables. Retain the original
package.
2. Plug the ISDN PRI cable into the PRI port.
3. Plug the ISDN PRI cable into the network terminating
equipment.
Note: A dual-port card needs two ISDN PRI cables if you are
using both ports.
Install for PRI QSIG
To install and configure the PRI Card in the DSU as a PRI/QSIG
variant, refer to the 3300 Universal NSU Install for PRI QSIG
instructions.
These are the steps that are required for installation and
programming:
1. Connect a computer to the PRI card.
2. Install a Direct Connection Device Driver on a computer.
3. Create a Dial-up Network connection on your computer.
4. Connect the computer to the PRI Card.
5. Use the IMAT Tool to complete required PRI configuration.
- 118 -