3300 ICP Technician's Handbook – Release 3.2
Install Symbol NetVision MiNET Phone Administrator Tool
The tool is found on the 3300 ICP software CD and must be
installed on a PC that is running Windows NT or Windows 2000.
To install the tool:
1. Insert the software CD into the CD-ROM drive.
2. Click \3rd_Party\Wireless\Administration_Tool
\MiNET<xxx>.exe.
3. Click Unzip to place files in C:\temp\symbol.
4. Click Close.
5. Open the C:\temp\symbol folder.
6. Click setup.exe.
7. Follow the instructions in the install wizard.
Install 3300 ICP as a Stand-alone IP Gateway
The 3300 ICP can be used as an IP Gateway providing the
functionality of both IP and Wireless MiNET protocols adjunct to a
legacy or third party PBX connected over DPNSS or Q.Sig trunks.
Before you begin
•
Ensure that Symbol Technologies have installed and
configured the Air Access Points.
•
Ensure you have the ESS ID numbers of the Air Access
Points.
•
Install the Symbol NetVision MiNET Phone Administrator
Tool on a Windows NT or Windows 2000 PC.
To install as a stand-alone system:
1. Install the 3300 ICP Controller.
2. Install the System ID Module.
3. Connect power to the 3300 Controller. The controller will come
up, in 15 to 20 minutes, with factory-installed software.
- 74 -