Mitel 3300 ICP Technician's Handbook page 118

3300 ICP Technician's Handbook – Release 3.2
9. Power up the unit.
Replace a Fiber Interface Module (FIM)
Remove a FIM
To remove a FIM from a Peripheral Unit:
WARNING: Power must not be applied to the Peripheral Unit
while the Fiber Interface Module is removed.
1. Power down the node.
2. Remove the front panels.
3. Attach the anti-static strap to your wrist.
4. If you need more room, remove the power converter and the
PSC.
5. Disconnect the fiber cables from the FIM. - Place dust caps on
the fiber cable connectors and on the FIM connectors. -
Remove the cable by sliding it through the cable port at the rear
of the cabinet.
6. Pull the FIM out gently from slot 17, unplugging it from the
backplane.
Install a FIM
To install a FIM in a Peripheral Unit:
WARNING: Power must not be applied to the Peripheral Unit
during the installation of the Fiber Interface Module.
1. Attach the anti-static strap to your wrist.
2. Unpack the FIM, and inspect it to ensure that it is not damaged.
3. Slide the FIM into the bottom of slot 17 until it connects with the
backplane firmly.
4. Fasten the FIM in place with the two screws provided or the
latch on the card guides.
5. Attach the FIM cable by following the steps in Connect the Fiber
Optic Cable.
- 110 -