3300 ICP Technician's Handbook – Release 3.2
Peripheral Unit
Overview of the Peripheral Unit Installation
To install a Peripheral Unit:
1. Unpack, position, and ground the Peripheral Unit.
2. Check the card layout.
3. Connect the fiber cable to the node.
4. Check the grounding.
5. Install the power converter.
6. Install the Peripheral Interface cards.
7. Cable the node to the MDF.
8. Power up the Peripheral Unit.
Note: For information about removing and replacing the front
panel of the cabinet, see Front Panels in Install Upgrades and
FRUs.
Proceed to Installing a DSU Node, Installing a SUPERSET HUB, or
return to System Installation Overview.
Unpack, Position, and Ground the Peripheral Unit
To unpack, position, and ground the node:
CAUTION: Power must not be applied to the Peripheral Unit
until you have installed the ground cable.
1. Unpack the peripheral node.
2. Check the contents against the packing list.
3. Visually inspect the node and attached equipment for damage.
Repack and return any damaged equipment.
4. Position the node.
5. Connect an external ground to the ground terminal on the rear
panel of the peripheral cabinet. Refer to the Safety Instructions
- 37 -