Connect Fiber Cable To The Peripheral Unit - Mitel 3300 ICP Technician's Handbook

3300 ICP Technician's Handbook – Release 3.2

Connect Fiber Cable to the Peripheral Unit

The fiber optic cable connects the FIM in the 3300 Controller to the
FIM in the Peripheral Unit.
To connect the fiber optic cable to the FIM in the peripheral node:
1. Review the guidelines for handling fiber optic cable.
2. Route the fiber optic cable through the cable port at the rear of
the peripheral cabinet into the cabinet. Extend the fiber cable
approximately 30 cm (1 ft) beyond the front of the cabinet.
3. Install a short piece of nylon spiral wrap over the cable at the
point where the cable exits the rear of the cabinet.
4. Close the sliding cable port door. Ensure that the door closes
on the nylon spiral-wrapped section of fiber cable.
- 39 -