G02 Circular Interpolation Cw (Radius-Specified) - Mitsubishi Electric Q Series Programming Manual

6 MOTION PROGRAMS FOR POSITIONING CONTROL

6.13.5 G02 Circular interpolation CW (Radius-specified)

Code
Circular interpolation (CW)
Function Radius-specified circular
interpolation
G 0
Format
[Explanation]
G02
2 X x Y y R r
(1) A circular arc of more than 180° is drawn at a negative circular arc radius (R)
value, or a circular arc of 180° or less is drawn at a positive R value.
Always use an incremental value to command the R value.
Radius value Negative
An error will occur if "the distance between start and end points" - radius
"circular arc error".
(2) If a complete round command (the start point is the same as the end point) is
specified in R-specified circular interpolation, an error (error code : 108) will occur
and no operation is performed. Therefore, specify the circular arc central
coordinates-specified for the complete round command.
(3) When this command is executed continuously, the acceleration or deceleration is
not made at the start or end point of a block because the status is not the exact
stop check mode.
(4) When the circular arc central coordinates and radius are specified simultaneously
for G02 (CW), the radius-specified circular interpolation has priority.
(5) The positioning data can be set by direct setting (numerical value) or indirect
setting (variable : #
The axes travel from the current position (start point) to the specified
coordinate position (end point) with a circular arc of the specified radius
(CW).
The travel speed is the specified feed rate.
F f ;
Feed rate
Feed rate command
Circular arc radius
End point X, Y coordinates
End point
Radius value
Start point
).
6 - 62
Positive
2 >