Special M-Code - Mitsubishi Electric Q Series Programming Manual

6 MOTION PROGRAMS FOR POSITIONING CONTROL

6.15 Special M-Code

Axis command
(Note-1)
M00
M01
M02
M30
M98
M99
M100
Other
M-codes
(Note-1) : The axis commands are X, Y, Z, U, V, W, A, B, CX, CY, CZ, CU, CV, CW, CA, CB, DX, DZ, DU, DV, DW, DA, DB,
EX, EY, EZ, EU, EV, EW, EA and EB.
(Note-2) : M-codes indicate except M00, M01, M02, M30, M98, M99 and M100.
The arguments of the special M-codes are shown in Table 6.4 below.
Table 6.4 Special M-Code argument list.
Radius Central Point
command (R) command (I, J)
M-code Feed
G-code
(F)
(Note-2)
6 - 121
H L N O P Remark
: May be specified.
Blank : Must not be specified.