Mitsubishi Electric Q Series Programming Manual page 460

APPENDICES
Table 1.3 Setting data error (1 to 99) list (Continued)
Error Erroneous
Check timing
code data
Parameter Interpolation control
40
block start
POINT
When the interpolation control unit of parameter block is different from the control
unit of the fixed parameters, an error code may not be stored with the combination
of units.
Refer to Section 6.11.6 for details.
Error cause
The interpolation control
unit of the parameter
block is different from
the control unit of the
fixed parameters.
APP - 5
Error
Corrective action
processing
Control with Set the same control unit
the control of the fixed parameters
unit of the and servo parameters.
fixed
parameters.