Home Position Return By The Dog Cradle Type - Mitsubishi Electric Q Series Programming Manual

7 AUXILIARY AND APPLIED FUNCTIONS

7.3.9 Home position return by the dog cradle type

[Control details]
Acceleration time Deceleration time
V
Home position
return start
(1) Dog cradle type
After deceleration stop by the proximity dog ON, if the zero point is passed after
traveling to reverse direction and turning the proximity dog OFF, the deceleration
stop is made. And it moves to direction of home position return again with creep
speed and the first zero point after proximity dog ON is home position in this
method.
(2) Home position return by the dog cradle type
Operation of home position return by the dog cradle type for setting the proximity
dog in the home position return direction is shown below.
Home position
Home position
return direction
return speed
Creep speed
4)
Home position
3)
Proximity dog
ON
Fig. 7.11 Home position return operation by the dog cradle type
(3) Home position return execution
Home position return by the dog cradle type is executed using the CHGA
instruction in Section 7.3.16.
When the home position return request is ON, the dog cradle type home position
return is also made even G28 of the Motion program.
1) It travels to preset direction of home
position return with the home position return
speed, and a deceleration stop is made by
the proximity dog ON.
2) After a deceleration stop, it travels to
reverse direction of home position return
1)
with the home position return speed.
3) If the zero point is passed by the proximity
dog OFF, a deceleration stop is made.
4) After a deceleration stop, it travels to
direction of home position return with the
creep speed, the home position return ends
with first zero point after the proximity dog
ON.
2)
The travel value in this range is stored in the monitor
register "home position return re-travel value".
The travel value in this range is stored in the monitor
register "travel value after proximity dog ON".
Zero point
7 - 29