2: Installation & Setup; Projector Installation; Step 1 - Carrying / Moving The Projector - Christie CP2000-ZX Setup Manual

2 Installation & Setup
This section explains how to install, connect and optimize the projector for delivery of superior
image quality. NOTE: The illustrations provided are to enhance the understanding of the written
material. They are graphical representations only and may not represent your exact projector
model.
2.1

Projector Installation

The following set of instructions explain how to install, connect and optimize the projector for smooth
operation.
product must be installed in a restricted access location.
or when it has been leveled.
Before you begin installation, it is important to fully understand all site requirements and
characteristics, and that you have the following tools and components on hand. NOTE: In general,
fasteners are metric sizes and require metric tools. However, to complete lamp installation, imperial
tools are required, which have been provided inside the lamp door of the projector.
 12" screwdrivers: Phillips #2 (magnetic) and flat
 19 mm and 7/8" wrenches.
 Assorted Allen keys
 Single-phase 30A connection of AC supply to the terminal block
 Installation site must have an easily accessible 30-32A breaker nearby
 Heat extractor (See
 Protective clothing / safety gear (required when handling the lamp)
 Lens cleaning tissue and solution

STEP 1 - Carrying / Moving the Projector

jection head a short distance.
jector. Avoid tilting the projector on the right side. This can introduce an air bubble
within the coolant hoses that can lead to an air lock.
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)
QUALIFIED TECHNICIAL REQUIRED for all installation procedures! This
Auto LampLOC™ must be run any time the projector is physically moved
STEP 5 - Connect Exhaust Ducting, on page 2-4
Four or more people are required to safely lift and hand-carry one pro-
Keep the projector as level as possible when lifting or carrying the pro-
for requirements)
2-1