Adjusting Tilt And Leveling; Adjusting Tilt; Adjusting Feet/Leveling; Carrying/Moving The Projector - Christie CP2000-M Setup Manual

Hide thumbs Also See for CP2000-M:
Table of Contents

Advertisement

3.10 ADJUSTING TILT AND LEVELING

Disconnect from AC for these initial alignments. Images are not yet needed.
For an ideal installation, the lens surface should be centered and parallel to the screen - this orientation
helps to ensure optimized lens performance with minimal offset. Choose a sturdy mounting surface. If
this position is not possible (such as when the projector is significantly higher than the center of the
screen), it is better to rely on offset rather than extra tilt.

3.10.1Adjusting Tilt

IMPORTANT! The front-to-back tilt of the projector must not exceed 15°. This limit ensures safe lamp
operation and proper position of the liquid cooling reservoir. For best optical performance, avoid
tilting the projector excessively. Use vertical offset of the lens instead.
Before adjusting tilt, ensure the projector is centered as much as possible to the theatre screen. Check
with theatre personnel for the degree of screen tilt, or measure this incline with a protractor at the
screen. Then tilt the projector to closely match the screen tilt angle by extending or retracting the
projector's 4 adjustable feet.

3.10.2Adjusting Feet/Leveling

To adjust the height and level of the projector, extend or
retract the feet by rotating them (Figure 3-10). Once
the required adjustment is made tighten the lock nut.
The 2 back feet measure 203mm (8") in order to
achieve a 15° tilt when necessary. NOTE: When
installing the CP2000-M/MR on the rack stand (108-
282101-xx or 108-272101-xx) the foot lock brackets
(119-100101-xx) must be installed for safety purposes.

3.10.3Carrying/Moving the Projector

2 people are required to safely lift and carry 1
projector a short distance. Titling the projector
excessively should be avoided as it can introduce air
bubbles within the coolant hoses, which can lead to an
air lock.
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)
CAUTION
Section 3: Installation & Setup
F
3-10 L
IGURE
EVELING
3-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp2000-mr

Table of Contents