Install New Lens - Christie Solaria CP2210 Setup Manual

Section 4: Maintenance
3. If necessary, remove the two cap screws securing the lens to the lens mount using a 5mm hex key (). The
cap screws are only needed when the projector is ceiling mounted.
4. Pull the lens out of the lens mount. The lens, motorized zoom and focus connectors disconnect when the
lens is pulled straight out of the mount.

4.4.2 Install New Lens

1. Remove the small rear cap. Keep the front cap on.
2. Align the mounts on the lens connector with the lens mount. Insert the lens until it connects with the
magnets on the mount. Once the lens makes contact with the magnetic plates it will be seated correctly and
the connector for motorized zoom and focus will be properly connected ().
3. Secure the lens clamp by pushing it down to the closed position.
4. For added stability, secure the cap screws provided on the lens-mount. If you have installed a large zoom
lens, one or more of the screws may be inaccessible - simply tighten those that are accessible.
NOTE: Recommended for heaviest lenses, such as 0.8:1 and 1.3-1.75:1.
4-10
Figure 4-7 Install Lens
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)