Table 48 Port Parameters; Table 49 Calculation Of Port Cycle Time - WAGO TEchDocs 765-4501/0100-0000 Manual

Planning
Parameters 100 to 147
Parameters 100 to 103, 132 and 140 configure IO-Link port X01.
Parameters 104 to 107, 133 and 141 configure IO-Link port X02.
...
Parameters 128 to 131, 139 and 147 configure IO-Link port X08.
No.
100,
104, ...
101,
105, ...
102,
106, ...
103,
107, ...
132,
133, ...
140,
141, ...
Value
Range
4 ... 63
64 ... 127 0.4 ms (01)
128 ...
191
192 ...
255
66 Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Parametername Value Range
DI Port X01/X02/... – 0: Normally open
CQ pin polarity
1: Normally closed
DI port X01/X02/... – 0: Deactivated
CQ pin signal filter
3: 3 ms filter time
15: 15 ms filter time
20: 20 ms filter time
DI port X01/X02/... – 0: Normally open
IQ pin polarity
1: Normally closed
DI port X01/X02/... – 0: deactivated
IQ pin signal filter
3: 3 ms filter time
15: 15 ms filter time
20: 20 ms filter time
DO port X01/X02/... 0: Normal
– IQ pin mode
1: static on
DO port X01/X02/... 0: Normal
– CQ pin mode
1: static on
Time Basis Factor
(Bits 6 and 7) (Bits 0 to 5)
0.1 ms (00) 4 ... 63
0 ... 63
1.6 ms (10) 0 ... 63
Reserved (11) 0 ... 63
Table 48: Port Parameters
Default Description
0 Pin 4 is a digital input. The input signal is
not inverted.
Pin 4 is a digital input. The input signal is
inverted.
0 No filter active for detecting a signal change
of the pin 4 digital input signal.
Filter time setting for detecting a signal
change of the pin 4 digital input signal. The
filter time is the amount of time the signal
must be present in order for a signal
change to be detected.
0 Pin 2 is a digital input. The input signal is
not inverted.
Pin 2 is a digital input. The input signal is
inverted.
0 No filter active for detecting a signal change
of the pin 2 digital input signal.
Filter time setting for detecting a signal
change of the pin 2 digital input signal. The
filter time is the amount of time the signal
must be present in order for a signal
change to be detected.
0 Pin 2 is a digital output.
Pin 2 is a digital output and switched on
(+24 VDC).
0 Pin 4 is a digital output.
Pin 4 is a digital output and switched on
(+24 VDC).
Table 49: Calculation of Port Cycle Time
Port Cycle Time Example
(Formula)
0.1 ms × factor 4: 400 μs
16: 1.6 ms
32: 3.2 ms
48: 4.8 ms
6.4 ms + 0.4 ms × factor 68: 8.0 ms
93: 18.0 ms
100: 20.8 ms
32 ms + 1.6 ms × factor 133: 40.0 ms
158: 80.0 ms
183: 120.0 ms
This value range is re- –
served
765-4501/0100-0000