Table 33 Port Parameters - WAGO 765-1505/100-000 Product Manual

765-1505/100-000
No.
95
96
Parameters 100 to 129
Parameters 100 and 101 configure port X01.
Parameters 104 and 105 configure port X02.
...
Parameters 128 and 129 configure port X08.
No.
100,
104, ...
101,
105, ...
Product manual | Version: 2.0.0
8DIO FLD EI DC 24V 2.0A
Parametername Value Range
Bluetooth timeout 6 ... 59 [s]
Reserved 0
Parametername Value Range
DIO port X01/X02/... 0: Normally open
– pin 4 mode
1: Normally closed
2: Output
3: Static On
DIO port X01/X02/... 0: Deactivated
– pin 4 input filter
3: 3 ms filter time
15: 15 ms filter time
20: 20 ms filter time
Default Description
30 Switch-off time of the Bluetooth
not used;
®
a new Bluetooth connection can be estab-
lished by an optical signal after the Blue-
®
tooth interface is reactivated.
The unit for the switch-off time is seconds.
Entering 0 is not allowed, since the Blue-
®
tooth interface must always switch off after
the switch-off time elapses.
0 –
Table 33: Port Parameters
Default Description
0 Pin 4 is a digital input. The input signal is
not inverted.
Pin 4 is a digital input. The input signal is
inverted.
Pin 4 is a digital output.
Pin 4 is a digital output and switched on
(+24 VDC).
0 No filter active for detecting a signal change
of the pin 4 digital input signal.
Filter time setting for detecting a signal
change of the pin 4 digital input signal. The
filter time is the amount of time the signal
must be present in order for a signal
change to be detected.
Planning
®
interface if
43