WAGO TEchDocs 765-4501/0100-0000 Manual page 101

765-4501/0100-0000
NOTICE
!
Put system in safe operating mode
Never perform a firmware update during ongoing operation of the system in which the
product is installed. Before any firmware update, the system must first be properly shut
down or put in a safe operating state.
Note
Create backup before update
When you update your product's firmware, the state of your product before the update, in-
cluding the firmware used up to that point, can no longer be reconstructed unless a
firmware and configuration data backup exists.
Changes to settings require operator or admin rights. If you do not have these, the Set-
tings tab is grayed out and cannot be edited.
To update the firmware, you need a firmware container file: FWUPDATE.ZIP. You can get
it from the Downloads section of the WAGO website: ü http://www.wago.com.
Proceed as follows to update the firmware:
1. In the left-hand column of the WAGO I/O Field Webserver, click the Settings menu
item.
ð The Device configuration tab appears.
2. Select the Firmware upgrade tab.
3. Click the [Select file] button.
ð A file selection dialog opens.
4. Select the firmware container file FWUPDATE.ZIP from this dialog.
ð The name of the selected firmware container file appears in the File field.
Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Figure 21: Settings Menu Item, Firmware Upgrade Tab
Commissioning
101