Table of Contents
Advertisement
Properties
4.4.3 Connection Technology
Property
Power connection
EtherNet/IP connection
IO-Link ports
Tightening torque
IO-Link Port (Class A)
Property
IO-Link Master (Class A)
Specification
Port mode
Transmission mode
Min. cycle time
Digital Input
Characteristic
Parameters
Recording cycle
Circuit
Indicators
Digital Output
Output voltage
Current
Residual current
Circuit
Voltage drop through high-side path
Self-protection
Maximum capacitive load
Maximum inductive load
Diagnostics
Actuator/Sensor Power Supply
Output voltage
20
Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Table 9: Connection technology
Value
PWR IN: M12 L-coded, 5-pin, plug
PWR OUT: M12 L-coded, 5-pin, socket
2 × M12, D-coded, socket, 4-pin
8 × M12, A-kodiert, Buchse, 5-polig
M12: 1.0 Nm
Table 10: IO-Link Port (Class A)
Value
V1.1
Pin 4: IO-Link: autoconfig, manual, tool-based; DI, DO
Pin 2: DI, DO
COM 1, COM 2, COM 3
400 µs (IO-Link frame type_2_1 with transmission
mode COM 3)
Type 3 (IEC 61131-2)
Digital software input filter: without, 3 ms ... 20 ms
The input signal change must be at most 2.5 kHz for
correct device-internal detection of changes.
However, it should be noted that the transfer and pro-
cessing of the process data (in the device and in the
controller) also take time and reduce the maximum in-
put signal change.
200 μs
The digital input is not resistant to reverse power feed-
ing.
The input voltage must not exceed the supply voltage.
On/off status LED
24 VDC, 1L powered
Normal operation: max. 2.0 A per channel
Overload operation: max. 2.4 A per channel, per
IEC 61131-2
Less than 1 mA
High-side driver
The digital output is not resistant to reverse power
feeding.
The input voltage must not exceed the supply voltage.
Less than 250 mV
Overcurrent, overload, overtemperature and overvolt-
age
100 μF parallel to 12 Ω; 10 Hz
1.15 H / 2 A; 0.2 Hz; DC13
Events: overcurrent, overload and overtemperature
24 VDC, 1L powered
765-4501/0100-0000
Advertisement
Chapters
Table of Contents
