Table 34 Port Parameters - WAGO 765-1205/100-000 Product Manual

Planning
Index
Subindex
0x2003.0
2
Indexes 0x2100 to 0x2170
Parameters with index 0x2100 configure port X01.
Parameters with index 0x2110 configure port X02.
...
Parameters with index 0x2170 configure port X08.
Index
Subindex
0x2100.0
1,
0x2110.0
1, ...
0x2100.0
2,
0x2110.0
2, ...
0x2100.0
3,
0x2110.0
3, ...
0x2100.0
4,
0x2110.0
4, ...
0x2100.0
5,
0x2110.0
5, ...
0x2100.2
4,
0x2110.2
4, ...
42 Product manual | Version: 2.0.0
8DIO FLD EC DC 24V 2.0A
Value Range Value Range
BT timeout 6 ... 59 [s]
Value Range Value Range
Port X01/X02/... 0: Digital input NO
Normally open
DI invert CQ pin
1: Digital input NC
Normally closed
Port X01/X02/... 0: No filter
Digital input filter CQ
30: 3 ms filter time
pin
150: 15 ms filter time
200: 20 ms filter time
Port X01/X02/... 0 (OFF)
1: On
DO Static on CQ pin
Port X01/X02/... 0: Digital input NO
Normally open
Digital mode IQ pin
1: Digital input NC
Normally closed
2: digital output
3: static on
4: Not supported
Port X01/X02/... 0: No filter
Digital input filter IQ
30: 3 ms filter time
pin
150: 15 ms filter time
200: 20 ms filter time
Port X01/X02/... 0 ... 32
Configuration IOL in-
put length
Default Description
30 Switch-off time of the Bluetooth
not used;
®
a new Bluetooth connection can be estab-
lished by an optical signal after the Blue-
®
tooth interface is reactivated.
The unit for the switch-off time is seconds.
Entering 0 is not allowed, since the Blue-
®
tooth interface must always switch off after
the switch-off time elapses.
Table 34: Port Parameters
Default Description
0 Pin 4 is a digital input. The input signal is
not inverted.
Pin 4 is a digital input. The input signal is
inverted.
0 No filter active for detecting a signal change
of the pin 4 digital input signal.
Filter time setting for detecting a signal
change of the pin 4 digital input signal. The
filter time is the amount of time the signal
must be present in order for a signal
change to be detected.
0 Pin 4 is a digital output.
Pin 4 is a digital output and switched on
(+24 VDC).
4 Pin 2 is a digital input. The input signal is
not inverted.
Pin 2 is a digital input. The input signal is
inverted.
Pin 2 is a digital output.
Pin 2 is a digital output and switched on
(+24 VDC).
Pin 2 is deactivated.
0 No filter active for detecting a signal change
of the pin 2 digital input signal.
Filter time setting for detecting a signal
change of the pin 2 digital input signal. The
filter time is the amount of time the signal
must be present in order for a signal
change to be detected.
0 Length of the input data
Set automatically by the configuration soft-
ware. Please do not change.
765-1205/100-000
®
interface if