WAGO TEchDocs 765-4501/0100-0000 Manual page 64

Planning
No.
11, 21, ... IO-Link port X01/
12, 22, ... IO-Link port X01/
13, 23, ... IO-Link port X01/
14, 24, ... IO-Link port X01/
15, 25, ... IO-Link port X01/
Parameters 90 to 96
Parameters 90 to 96 configure the module.
64 Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Parametername Value Range
3: Digital input
4: Digital output
0 ... 4
X02/... – Validation
0: No device check
and backup
1: Type-compatible
to device V1.0
2: Type-compatible
to device V1.1
3: Type-compatible
to device V1.1,
backup and restore
4: Type-compatible
to device V1.1, re-
store only
0 ... 2
X02/... – IQ behavior
0: Not supported
1: Digital input
2: Digital output
0, 4 ... 191
X02/... – Port cycle
time
0, 1 ... 65535
X02/... – Vendor ID
0, 1 ... 16777215
X02/... – Device ID
Default Description
Pin 4 is a digital input.
Pin 4 is a digital output.
0 Validation and backup settings
The IO-Link master does not verify the
compatibility of the connected IO-Link de-
vice.
The IO-Link master uses the manufacturer
ID and device ID to check whether the con-
nected IO-Link device is compatible and
supports specification V1.0.
The IO-Link master uses the manufacturer
ID and device ID to check whether the con-
nected IO-Link device is compatible and
supports specification V1.1.
The IO-Link master uses the manufacturer
ID and device ID to check whether the con-
nected IO-Link device is compatible and
supports specification V1.1. The IO-Link
master uses backup and restore functions
to back up the IO-Link device parameters
and load them onto the IO-Link device after
the device is replaced.
The IO-Link master uses the manufacturer
ID and device ID to check whether the con-
nected IO-Link device is compatible and
supports specification V1.1. The IO-Link
master uses the restore function to load
stored parameters onto the IO-Link device
after the device is replaced.
0 Configuration of pin 2
Pin 2 is not used.
Pin 2 is a digital input.
Pin 2 is a digital output.
0 Port Cycle Time
0: calculated by IO-Link master
4 ... 191: see table "Calculation of Port Cy-
cle Time"
0 Manufacturer ID
If validation is used: expected manufacturer
ID of the connected IO-Link device.
Manufacturer ID: see the documentation of
the IO-Link device used.
Value 0 if no validation is used.
0 Device ID
If validation is used: expected device ID of
the connected IO-Link device.
Device ID: see the documentation of the
IO-Link device used.
Value 0 if no validation is used.
765-4501/0100-0000