WAGO TEchDocs 765-4501/0100-0000 Manual page 106

Commissioning
2. Enter your username and password into the corresponding fields.
3. Click the [Sign in] button.
ð If you have entered a known username correctly, you can now work with the WAGO I/
O Field Webserver with this user's specified rights. The username that was used to
log on is shown in the upper left-hand corner. The Sign in menu item changes to
Sign out.
Logging Users off
Proceed as follows to log a user off:
• From the Webserver main menu (left), select the Sign out menu item.
ð You can now no longer work in the WAGO I/O Field Webserver with the rights you
had been using till this point. The username used to log on is no longer shown in the
upper left-hand corner. The Sign out menu item changes back to Sign in.
Guest User Access
By default, the Webserver recognizes the user guest without a password; this was set
up for initial access or guest access.
Initial Login as Administrator
Upon delivery or after a reset to the factory settings, the WAGO I/O Field Webserver can
be accessed with the username root and password password. This combination has
administrator rights.
Note
Change the administrator password immediately after commissioning. The factory
default setting is widely known and does not provide adequate protection.
106 Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Figure 24: Sign in Menu Item – Input Screen for Username and Password
765-4501/0100-0000