Mechanical Safety; Thermal Safety; Indirect Safety - WAGO TEchDocs 765-4501/0100-0000 Manual

765-4501/0100-0000

2.3 Mechanical Safety

• Cooling of the product must not be impaired. Ensure air can flow freely and that the
minimum clearances from adjacent products/areas are maintained.
• Do not install the product on or in the vicinity of easily flammable materials.
• Before startup, please check the product for any damage that may have occurred dur-
ing shipping. Do not put the product into operation in the event of mechanical damage.

2.4 Thermal Safety

• The surface of the housing heats up during operation. Under special conditions (e.g., in
the event of a fault or increased surrounding air temperature), touching the product
may cause burns. Allow the product to cool down before touching it.
• If the surface temperature of the product can exceed 55 °C, wear protective gloves and
attach protective covers and/or touch-proof protection.

2.5 Indirect Safety

• Only use a dry or cloth or a clothed dampened with water to clean the product. Do not
use cleaning agents, e.g., abrasive cleaners, alcohols or acetone.
• Do not allow the product to come into contact with ketones (e.g., acetone) or chlori-
nated hydrocarbons (e.g., dichloromethane) under any circumstances.
• Do not use hard objects that could cause scratches for cleaning.
• Clean tools and materials are imperative for handling the product.
• If automation solutions are implemented that can cause personal injury or major prop-
erty damage in the event of failure, you must take appropriate measures to ensure that
the system remains in a safe operating state even in the event of failure.
• Before installation and operation, please read the product documentation thoroughly
and carefully. In addition, note the information on the product housing and further infor-
mation, e.g. at ü www.wago.com/<item number>.
• Only permit skilled personnel approved by WAGO to perform repair work.
Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Safety
13