Table 47 Module Parameters - WAGO TEchDocs 765-4501/0100-0000 Manual

765-4501/0100-0000
No.
90
91
92
93
94
95
96
Product manual | Version: 1.1.0
8PORT IOL-A FLD EI DC 24V 2.0A
Parametername Value Range
DIO process data 0: Port-based
layout
1: Pin-based
DO substitute mode 0: Set to low
1: Use substitute val-
ues
2: Hold last state
DO substitute values 0 ... 65535
Disable force mode 0: Enable force
mode
1: Disable force
mode
Disable bluetooth 0: Enable bluetooth
1: Disable bluetooth
Bluetooth timeout 6 ... 59 [s]
Reserved 0
Table 47: Module Parameters
Default Description
0 Order of the process data of the digital in-
puts and digital outputs:
Bit 0 = port X01 pin 4,
Bit 1 = port X01 pin 2,
bit 2 = port X02 pin 4,
bit 3 = port X02 pin 2,
...
Order of the process data of the digital in-
puts and digital outputs:
Bit 0 = port X01 pin 4,
Bit 1 = port X02 pin 4,
Bit 2 = port X03 pin 4,
Bit 3 = port X04 pin 4,
...
Bit 8 = port X01 pin 2,
Bit 9 = port X02 pin 2,
...
0 Set all digital outputs to low level in the
event of error
Set digital outputs to a pre-defined substi-
tute value in the event of error.
If this setting is used, the value of the "DO
substitute value" parameter determines the
substitute value.
Hold digital outputs at their last value in the
event of error
0 Substitute value for the digital outputs if the
"Use substitute values" setting is used. The
input depends on the "DIO process data
layout" parameter.
Use a binary-to-decimal converter to calcu-
late this value.
0 The "Forcing" operating mode may be
used.
The "Forcing" operating mode must not be
used.
®
0 The Bluetooth interface can be enabled by
an optical signal of a mobile device and in
connection with the WAGO I/O Field app.
®
The Bluetooth interface cannot be enabled
by an optical signal of a mobile device and
in connection with the WAGO I/O Field app.
30 Switch-off time of the Bluetooth interface if
not used.
A new Bluetooth connection can be estab-
lished by an optical signal after the Blue-
tooth interface is enabled again.
The unit for the switch-off time is seconds.
Entering 0 is not allowed, since the Blue-
tooth interface must always switch off after
the switch-off time elapses.
0 –
Planning
65