Table 40 Port Parameters - WAGO 765-4203/0100-0000 Product Manual

Planning
Index Subindex Parametername
0x2002.01
0x2002.02
0x2003.01
0x2003.02
Indexes 0x2100 to 0x2130
Parameters with index 0x2100 configure port X01.
Parameters with index 0x2110 configure port X02.
Parameters with index 0x2120 configure port X03.
Parameters with index 0x2130 configure port X04.
Index Subindex Parametername
0x2100.01,
0x2110.01, ...
0x2100.02,
0x2110.02, ...
46 Product manual | Version: 1.0.0
4PORT IOL-A FLD EC DC 24V 2.0A
Value Range
DO substitue 0: Set to low
mode
1: Use substitute val-
ues
2: hold last
DO substitue value 0 ... 65535
Disable BT 0: Activation of BT in-
terface is allowed
1: Disable activation of
BT interface
BT timeout 6 ... 59 [s]
Value Range
Port X01/X02/... 0: Digital input NO Nor-
mally open
DI invert CQ pin
1: Digital input NC Nor-
mally closed
Port X01/X02/... 0: No filter
Digital input filter
CQ pin
30: 3 ms filter time
150: 15 ms filter time
200: 20 ms filter time
765-4203/0100-0000
Default Description
0 Set all digital outputs to low level in
the event of error
Set digital outputs to a pre-defined
substitute value in the event of error.
If this setting is used, the value of the
"DO substitute value" parameter de-
termines the substitute value.
Hold digital outputs at their last value
in the event of error
0 Substitute value for the digital outputs
if the "Use substitute values" setting is
used. The input depends on the "PD
layout configuration" parameter.
Use a binary-to-decimal converter to
calculate this value.
®
0 The Bluetooth interface can be en-
abled by an optical signal of a mobile
device and in connection with the
WAGO I/O Field app.
®
The Bluetooth interface cannot be
enabled by an optical signal of a mo-
bile device and in connection with the
WAGO I/O Field app.
30 Switch-off time of the Bluetooth
face if not used;
®
a new Bluetooth connection can be
established by an optical signal after
®
the Bluetooth interface is reactivated.
The unit for the switch-off time is sec-
onds. Entering 0 is not allowed, since
®
the Bluetooth interface must always
switch off after the switch-off time
elapses.
Table 40: Port Parameters
Default Description
0 Pin 4 is a digital input. The input sig-
nal is not inverted.
Pin 4 is a digital input. The input sig-
nal is inverted.
0 No filter active for detecting a signal
change of the pin 4 digital input sig-
nal.
Filter time setting for detecting a sig-
nal change of the pin 4 digital input
signal. The filter time is the amount of
®
inter-