Maintenance
Remove the Handset Remotely
You may receive the SIP Notify to reset the handset's IPEI number from the call control system. The notification
contains the handset index number. For example,
For more information about SIP Notify authentication, see
48.
You can reset the handset's IPEI number remotely in this way.
Before you begin
Ensure that the handset and the extensions aren't used.
Procedure
Send SIP Notify from the call control system.
The handset's IPEI number is reset as
Reset the Base Station to Factory Defaults
The reset button is located on the bottom edge of the base station.
Before you begin
The Factory reset from button field in the Management Settings page must be enabled. For more information,
see
Set Up Management Settings, on page 64
Procedure
Press and hold the reset button for 10 seconds.
You can release the button when the LED turns red.
Reset the Handset to Factory Defaults
Occasionally, you need to reset a handset to factory defaults. The reset deletes any information you stored in
the handset (for example, ringtones). Any content that is controlled by the base station (for example, system
configuration) is not deleted.
Event:reset-ipei-for-handset;hs=1
Configure the SIP Notify Authentication, on page
and the handset isn't configured to the extension.
FFFFFFFFFF
and
Management Web Page Fields, on page
Cisco IP DECT 6800 Series Administration Guide
Remove the Handset Remotely
.
104.
149