Cisco 6800 Series Administration Manual page 47

Hardware Installation
Caution
Charge the battery with the handset charger provided. If you use another method, you can damage the battery,
the handset, or your surrounding area.
Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).
Caution Don't charge the battery in hazardous environments or where there's explosion danger.
When you place the handset into the charger, it turns on (if not already on) and displays a message that the
handset is charging. The handset screen dims and turns off at the configured time.
If the LED on the handset starts to flash, the handset is updating its firmware.
Before you begin
Set up the cradle as described in
Ensure that your handset charger is plugged into the electrical outlet.
Procedure
Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.
The handset beeps, screen turns on, and displays a message that the handset is charging. If this doesn't happen,
remove the handset from the charger and try again.
If the handset beeps continuously while on the charger, try the troubleshooting solution available in the section
Handset Beeps Continuously While in the Charger, on page
Set Up the Charging Cradle, on page
168.
Cisco IP DECT 6800 Series Administration Guide
Charge the Handset Battery
38.
39