Cisco 6800 Series Administration Manual page 60

Connect the Handset to the Base Station
What to do next
• On each handset, perform
Connect the Handset to the Base Station
After you configure the handset to connect to the base station, it registers. You can make calls when the
registration is complete.
If your users perform this procedure, then you need to give them the procedure and the access code.
Before you begin
• The handset battery must be installed. See
• The handset battery must be charged. See
• The handset must be configured on the base station as described in
Procedure
Step 1 Turn on the handset. See
Step 2
Press Menu
Step 3 Select Connectivity > Register.
Step 4
Press Select.
Step 5 (Optional) Enter the access code in the AC field.
Step 6
Press Ok.
Turn On Your Handset
Procedure
Press and hold Power/End
Add a Repeater
If you have a 110 Single-Cell Base Station, you can extend coverage in your location with 110 Repeaters.
You can have up to 6 repeaters.
If you have a 210 Multi-Cell Base Station, you can extend coverage in your location with 110 Repeaters. You
can have up to 3 repeaters per base station.
Cisco IP DECT 6800 Series Administration Guide
52
Connect the Handset to the Base Station, on page
on page 49 and you need the base station access code (AC).
Turn On Your Handset, on page
.
Install the Battery in the Handset, on page
Charge the Handset Battery, on page
52.
until the screen turns on.
Phone Administration
52.
35.
38.
Add Handsets to the Base Station,