Cisco 6800 Series Administration Manual page 109

Monitoring
Field
User Priority
Synchronization
Table 16: SIP/RTP Settings Section Fields
Field
Use Different SIP Ports
RTP Collision Detection
Always reboot on
check-sync
Outbound Proxy Mode
Contents Description
Integer Defines the user priority. These values can be used to
prioritize different classes of traffic (voice, video,
Range: 0–7
data).
Default: 0
Values: Indicates if the VLAN ID automatically synchronizes
between the base stations in the chain.
• Disabled
This field only displays on the Cisco IP DECT 210
• Enabled (default)
Multi-Cell Base Station.
Contents Description
Values: Indicates SIP signaling ports.
• Disabled (default)
• Enabled
Set this field to Enabled for single-base systems.
Values:
• Disabled
• Enabled (default)
Values: Indicates if the base station reboots when a new
configuration is loaded.
• Disabled (default)
• Enabled
Values: Indicates the outbound proxy use.
• Use Always (default)
• Only Initial Request
Cisco IP DECT 6800 Series Administration Guide
Network Web Page Fields
• 0—best effort
• 1—lowest priority
• 7—highest priority
• Disabled—The Local SIP Port field specifies the
source port used for SIP signaling in the system.
• Enabled—The Local SIP Port field specifies the
source port used for the first user agent (UA)
instance. Succeeding UAs get successive ports.
• Disabled—When two sources have the same
SSRC, the second source is discarded.
• Enabled—The device accepts all sources.
• Use always—All outbound calls as sent to the
outbound proxy.
• Only initial request—Only use the outbound
proxy for initial SIP requests.
101