Cisco 6800 Series Administration Manual page 56

Configure the SIP Notify Authentication
address of the base station so that you can sign in and change the settings. You can change the predefined
static IP address to another static IP address.
You may need to change these specific fields, as instructed by your service provider:
• VLAN
• Use Different SIP Ports
• RTP Port
For information on the fields, see
Before you begin
Connect to the base station web page as described in
Procedure
Step 1
Click Network.
Step 2 If your network doesn't use DHCP, set the DHCP/Static IP field to Static IP.
If you select Static IP, you must configure these additional fields:
• IP Address
• Subnet Mask
• Default Gateway
• DNS (Primary)
• DNS (Secondary)
Step 3
If you are setting up a single-base system, set Use Different SIP Ports to Enabled.
Step 4 Set the RTP Port field, as instructed by your service provider.
Step 5
Configure the remaining network fields, as described in
Step 6 Click Save.
What to do next
Add Handsets to the Base Station, on page 49
Configure the SIP Notify Authentication
When the base station receives the SIP Notify, you can configure the base station to request credentials for
the SIP notification.
The base station uses TCP, UDP, or TLS to receive the SIP Notify from the system. When the SIP transport
is TCP or UDP, the base station requests authorization. The credentials from the system should match the
credentials of the handset extension. If the credentials don't match, the base station sends an authorization
error to the system.
Cisco IP DECT 6800 Series Administration Guide
48
Network Web Page Fields, on page
Sign in to the Administration Web Page, on page
Network Web Page Fields, on page
Phone Administration
99.
99.
42.