Cisco 6800 Series Administration Manual page 115

Monitoring
Field
Dual Cell Specific File
Auto Resync Polling
Auto Resync Time
Auto Resync Days
Auto Resync Periodic
(Min)
Auto Resync Max Delay
(Min)
DHCP Controlled Config
Server
DHCP option priority
Table 25: Syslog/SIP Log Section Fields
Field
Upload of SIP Log
Contents Description
This field is new in Firmware Release 5.0.
Identifies the configuration file for the dualcell system.
The filename is the chain id.
This field only displays on the 110 Single-Cell Base
Station.
Values: Controls the ability to look for new configuration files
for the automatic synchronization.
• Disabled (default)
• Enabled
hh:mm Indicates the time (24-hour clock) that the base station
looks to resync the configuration file.
Default: 00:00
This field is available when Auto Resync Polling is
Maximum: 23:59
enabled.
Minimum: 0 Indicates the number of days between resync
operations.
Maximum: 364
This field is available when Auto Resync Polling is
enabled.
Minimum: 0 Indicates the resync time in minutes.
Maximum: 65535 This field is available when Auto Resync Polling is
enabled.
Default: 15 Indicates the time delay, in seconds. Set different
delay times for each base station to prevent them from
Minimum: 0
asking for new configuration files at the same time.
Maximum: 1439
This field is available when Auto Resync Polling is
enabled.
Identifies the configuration server.
Default: 66, 160, 159, Identifies the priority of the DHCP options.
150, 60
Contents Description
Values Indicates if low-level SIP debug messages are to be
saved to the server. SIP logs are saved in the file
• Disabled (default)
format:
• Enabled
<MAC_address><Time_stamp>SIP.log
Cisco IP DECT 6800 Series Administration Guide
Management Web Page Fields
• Disable—No automatic sync
• Enable—Automatic sync enabled.
107