Set Up The Cisco Ip Dect 6800 Series (Workflow) - Cisco 6800 Series Administration Manual

Cisco IP DECT 6800 Series
Feature
General changes

Set Up the Cisco IP DECT 6800 Series (Workflow)

Use the following workflow to guide you through the setup of the 110 Single-Cell Base Station or 210
Multi-Cell Base Station in your system.
Note
This workflow is a plan for a single-base system. If you need to add another 110 Single-Cell Base Station or
Cisco IP DECT 210 Multi-Cell Base Station, or additional 210 Multi-Cell Base Stations, the additional base
stations require additional knowledge.
Installation can take two approaches:
• Automatic: In this scenario, the base station and handsets are preconfigured by the service provider.
• Manual: In this scenario, the base station and handsets must be configured with the administration web
After you complete this workflow, you can configure directories, security, and additional features. For more
information, see
Procedure
Step 1
Step 2
Step 3
pages. The service provider needs to provide information to enable the system to communicate with the
call control service.
Phone Administration, on page
Command or Action
Installation Requirements, on page 19
Install the Base Station, on page 25
Perform a Site Survey, on page 144
Set Up the Cisco IP DECT 6800 Series (Workflow)
New or Updated Sections
New tasks:
• Add a Second Line to a Handset, on page 71
• Share a Line Between Handsets, on page 72
• Handset Won't Register (Automatic
Configuration), on page 164
• Handset Won't Register (Manual Configuration),
on page 165
• Base Station LED Flashes Red and Handset
Displays No SIP Reg Message, on page 166
41.
Purpose
Prepare for system installation.
Check that the base station and network can
communicate. If the system uses automatic
configuration, the system automatically
downloads its configuration.
Temporarily place the base station in the
planned locations and ensure that the
Cisco IP DECT 6800 Series Administration Guide
13