Cisco 6800 Series Administration Manual page 147

Monitoring
Configuration Web Page Fields
The Configuration web page of the base station displays a read-only version of the base station configuration
file. The file is stored in the /Config folder TFTP server. Each base station has a unique configuration file,
based on the MAC address.
You can make changes to a file in these ways:
• [Recommended method] Change the settings in the base station web pages and export the file for a
• Export the file, make changes, and then upload the file.
Note If you choose to make manual changes, you must ensure that you retain all formatting. Otherwise, the phone
may not be set up correctly.
Syslog Web Page Fields
The Syslog web page displays a live feed of system-level messages of the current base station. The Syslog
level field in the Management web page controls the messages that are logged.
Note When the base station reboots, a new syslog starts and the previous information is lost. If you have a problem
and plan to reboot, save the syslog file to your computer before you do the reboot.
If the Syslog level field is set for debug logs, additional information is written to the syslog. You should only
capture debug logs for a short amount of time to minimize system congestion.
Note You will see frequent messages like this:
Sent to udp:xxx.xxx.xxx.xxx:xxxx at mm/dd/yyyy hh:mm:ss (4 bytes), where
xxx.xxx.xxx.xxx:xxxx is the IP address and port, mm/dd/yyyy is the date, and hh:mm:ss is the time.
These are the keep alive messages and you can ignore them.
SIP Log Web Page Fields
The SIP Log web page displays a live feed of SIP server messages of the system (single cell, dualcell or
multicell). The information is also saved as a file on the TFTP server. Logs are saved in 2 blocks of 17 KB,
and when one block is full, the other one is used (it will overwrite previous content).
Filename: <MAC_address><time_stamp>SIP.log
backup.
Configuration Web Page Fields
Cisco IP DECT 6800 Series Administration Guide
139