Cisco 6800 Series Administration Manual page 118

Country Web Page Fields
Field
Required branch
Country Web Page Fields
These are the fields displayed on the Country/Time Settings web page of the base station.
Table 30: Country/Time Settings Web Page Fields
Field
Select country
State / Region
Notes
Select Language
Time Service
Time Server
Allow broadcast NTP
Refresh time (h)
Set timezone by
country/region
Timezone
Set DST by
country/region
Cisco IP DECT 6800 Series Administration Guide
110
Contents Description
8-character string Indicates the branch of firmware .
When you update this field, the branch doesn't require
the leading zeros. That is, if the branch is "b003", you
can input the version as 3.
Contents Description
List of countries Identifies the country where the base station is located.
List of states or regions, Identifies the state or region where the base station is
based on the country located.
selected.
Text Contains notes about the settings.
List of languages Identifies the language for the base station web pages.
Text Displays the defined time service.
Text Identifies the DNS name or the IP address of the
network time server.
Note
Check box Identifies if the time server should be used for all
devices.
Default: checked
Integer (1-24) Identifies the frequency that the base station syncs its
time (in hours) with the time server.
Default: 24
Check box Indicates that the base station uses the timezone setting
from the country and state/region fields in this screen.
Default: checked
When this box is checked, you can't update some of
the other fields in this table.
0 or hh:mm Indicates the time zone in GMT or UTC format.
Minimum: -12:00
Maximum: +13:00
Check box Identifies if the daylight savings time (DST) for the
state or region can be used.
Default: checked
Only IPv4 addresses are supported
Monitoring