Reboot The Base Station Remotely; Remove The Handset From The Web Page - Cisco 6800 Series Administration Manual

Reboot the Base Station Remotely

Procedure
Step 1
Access the Home/Status page.
Step 2 Click Reboot or Forced Reboot.
Reboot the Base Station Remotely
You may receive the SIP Notify to reboot the base station from the call control system. The SIP Notify contains
the event
initiates a reboot.
For more information about SIP Notify authentication, see
48.
You can reboot the base station remotely in this way.
Before you begin
Ensure that the base station is idle.
Procedure
Send SIP notify from the call control system.
The base station reboots automatically.

Remove the Handset from the Web Page

You may need to remove the handset, if the handset is faulty or there are problems with the handset. You can
remove the handset this way from the Extensions web page.
Before you begin
Connect to the base station web page as described in
Procedure
Step 1 Click Extensions.
Step 2
Click the link in the Extension Info column for the handset.
Step 3 Set the IPEI number to
Step 4
Click Save.
Cisco IP DECT 6800 Series Administration Guide
148
. If the parameter
Event:check-sync
.
FFFFFFFFFF
Sip_Check_Sync_Always_Reboot
Configure the SIP Notify Authentication, on page
Sign in to the Administration Web Page, on page
Maintenance
is set to , the base station
On
42.