Cisco 6800 Series Administration Manual page 57

Phone Administration
You can enable the authorization and enter the domain name for the system in the Servers web page or in the
configuration file (.xml). For information about the fields, see
Configure the notification fields this way in the configuration file (.xml).
<Auth_Resync_reboot_1_>enable</ Auth_Resync_reboot_1_>
<Reversed_Auth_Realm_1_>n</Reversed_Auth_Realm_1_>
Where,
Before you begin
Connect to the base station web page as described in
Procedure
Step 1
Click Servers.
Step 2 Set Auth Resync reboot to Enabled.
Step 3
In the Reversed Auth Realm field, enter the domain name.
Step 4 Click Save.
What to do next
The SIP Notify can contain the events to reset IPEI number of the handset or reboot the base station.
For more information, see
on page
Add Handsets to the Base Station
You need to configure the handsets on the base station so that they can connect and communicate.
You can add and register handsets one at a time, or you can set up multiple handsets.
• Single handset setup: At the end of this procedure, the base station has the information about the handset
• Multiple handset setup: At the end of this procedure, the base station is set up, but you need to complete
You may find the
Before you begin
Connect to the base station web page as described in
The base station needs to be connected to the network and the green LED lit.
Procedure
Step 1 Click Extensions.
indicates the domain name for the system.
n
Remove the Handset Remotely, on page 149
148.
set up, but the handset is not registered to the base station and able to make calls.
user-specific configuration to assign the handset to the correct person.
Handset Configuration Parameters Worksheet, on page 185
Add Handsets to the Base Station
Servers Web Page Fields, on page
Sign in to the Administration Web Page, on page
or Reboot the Base Station Remotely,
helpful.
Sign in to the Administration Web Page, on page
Cisco IP DECT 6800 Series Administration Guide
92.
42.
42.
49