Cisco 6800 Series Administration Manual page 73

Phone Administration
Procedure
Step 1
Click Management.
Step 2 Configure the Settings, Configuration, and Syslog/SIP Log fields, as described in the Settings table in
Management Web Page Fields, on page
At minimum, you must configure this field:
• Emergency Numbers
Step 3
Do one of these actions:
• If you changed the VLAN field, click Save and Reboot.
• For all other changes, click Save.
Configure Text Messaging
You may want to change the settings in the Text Messaging area in the Management web page. These fields
control the ability of the handset to send and receive text messages. By default, text messages are disabled.
After being enabled, you can set up the system to allow messages only within your system or to allow messages
to and from other systems.
Note If you enable text messaging, make sure that you tell your users.
Before you begin
Connect to the base station web page as described in
Procedure
Step 1
Click Management.
Step 2 Configure the text message fields, as described in the Text Messaging table in
on page
Step 3 Click Save.
Configure Paging
You can configure a paging group to page a group of handsets. You send a page to a group of handsets in the
same network.
You can add a handset to up to three paging groups. Each paging group has a unique multicast port and number.
The phones within a paging group must subscribe to the same multicast IP address, port, and multicast number.
104.
104.
Sign in to the Administration Web Page, on page 42
Cisco IP DECT 6800 Series Administration Guide
Configure Text Messaging
Management Web Page Fields,
65