Cisco 6800 Series Administration Manual page 76

Set Up Call Quality Statistics to Call Server
Set Up Call Quality Statistics to Call Server
You can send the call quality statistics to call control system after the call ends. The statistics is sent from the
RTP media unit to the SIP control unit after each call ends in a Multicell system. You can view the statistics
log in the SIP Log web page.
You enable the data collection with the Servers web page or in the configuration file (.xml).
Enable the call statistics this way in the configuration file (.xml):
<Call_Statistics_In_SIP_n_>Yes</Call_Statistics_In_SIP_n_>
Where,
Before you begin
Connect to the base station web page as described in
Procedure
Step 1 Click Servers.
Step 2
Set Call Statistics in SIP to Enabled.
Step 3 Click Save.
Configure Alarms
You can set up the handsets to raise an alarm when the Emergency button on the top of the 6825 Handset or
6825 Ruggedized Handset is pressed.
Note The 6823 Handset doesn't have an Emergency button.
Before you begin
Connect to the base station web page as described in
You can configure an alarm server in the Management Settings page. See
page 64
calls to the defined number.
Procedure
Step 1
Click Alarm.
Step 2 Configure the alarm fields, as described in
Step 3
Click Save.
Cisco IP DECT 6800 Series Administration Guide
68
is the server number.
n
and Management Web Page Fields, on page
Sign in to the Administration Web Page, on page
Sign in to the Administration Web Page, on page
104. If you don't configure an alarm server, you can make
Alarm Web Page Fields, on page
Phone Administration
42.
42.
Set Up Management Settings, on
129.