Set Up A 110 Repeater In Your Network - Cisco 6800 Series Administration Manual

Cisco IP DECT 6800 Series
Step 15
What to do next
If you need to set up a 110 Repeater, go to
Related Topics

Set Up a 110 Repeater in Your Network

Use the following workflow to configure a 110 Repeater to work with your 110 Single-Cell Base Station.
Note Do not connect the repeater to power until instructed to in
Before you begin
The base station must be installed and active.
At least one handset must be installed and active.
Procedure
Step 1
Step 2
Step 3
Step 4
Command or Action
(Optional) Back Up the System Configuration,
on page 150
Manual Configuration, on page 46
Automatic Configuration, on page 43
Command or Action
Installation Requirements, on page 19
Perform a Site Survey, on page 144
Perform one of these:
• Mount the Base Station or Repeater on the
Ceiling, on page 26
• Mount the Base Station or Repeater on a
Desk, on page 30
• Mount the Base Station or Repeater on the
Wall, on page 31
Sign in to the Administration Web Page, on
page 42
Purpose
Perform a backup to save the configuration.
Set Up a 110 Repeater in Your Network, on page
Add a Repeater, on page
Purpose
Prepare for system installation.
Temporarily place the repeaters in the planned
locations and ensure that the placement gives
good coverage before you permanently install
the hardware.
For more information, see the Cisco IP DECT
Phone 6800 Series Deployment Guide.
Mount the repeater in the desired location.
Connect to the base station web page from your
browser.
Cisco IP DECT 6800 Series Administration Guide
Set Up a 110 Repeater in Your Network
15.
52.
15