Cisco 6800 Series Administration Manual page 107

Monitoring
Field
Auth Resync reboot
Reversed Auth Realm
Network Web Page Fields
These are the fields displayed on the Network Settings web page of the base station.
Table 13: IP Settings Section Fields
Field
DHCP/Static IP
IP Address
Subnet Mask
Default Gateway
Via DHCP priority
DNS (Primary)
DNS (Secondaries)
Contents
Values:
• Enabled (default)
• Disabled
String
Maximum up to 64 characters
Contents
Values:
• DHCP (default)
• Static
IPv4
Description
This field is new for Firmware Release 5.0.
Enabled: Indicates that the authentication is required for SIP
notification if the event is
reset-ipei-for-handset
and the protocol isn't TLS.
check-sync
This field is new for Firmware Release 5.0.
Indicates the server that the handset extension uses.
Description
Indicates the method that the device gets the TCP/IP
parameters.
• DHCP—Automatically allocated from a pool of
addresses. If DHCP is used, the other IP settings
or options can't be set.
• Static—Manually set.
Indicates the IPv4 address of the device.
Can only be changed if DHCP is not enabled.
Indicates the 32-bit subnet mask of the device.
Can only be changed if DHCP is not enabled.
Indicates the IPv4 address of the default network
router or gateway.
Can only be changed if DHCP is not enabled.
Indicates the IPv4 address of the main server used for
Domain Name System (DNS) queries.
Mandatory when DHCP is not used.
Can only be changed if DHCP is not enabled.
Indicated the alternate DNS server.
Can only be changed if DHCP is not enabled.
Cisco IP DECT 6800 Series Administration Guide
Network Web Page Fields
or
99