Cisco 6800 Series Administration Manual page 127

Monitoring
Field
Data Sync
Primary Data Sync IP
Base Replacement Timeout
(15-255 Min)
Contents
Values:
• Multicast (default)
• Peer-to-peer
IP address
Default: 60 minutes
Cisco IP DECT 6800 Series Administration Guide
Dual Cell Web Page Fields
Description
Indicates the type of data
synchronization.
• Multicast—Requires
Multicast/IGMP to be enabled on
the call control system.
• The multicast port range and
IP addresses used is calculated
from the chain ID.
• The multicast feature uses the
port range: 49200 to 49999.
• The multicast feature IP range:
224.1.0.0 to 225.1.0.0.
• Multicast uses UDP.
• Peer-to-peer—Use this mode when
the network doesn't allow Multicast.
For multicast operation, enable the
Multicast/IGMP on your switches.
Otherwise, use Peer-to-peer mode.
Indicates the base station data
synchronization IP address.
When Data Sync is set to multicast, this
base IP is selected automatically.
The data sync feature uses the port range
of 49200 to 49999.
When Data Sync is set to Peer-to-peer,
you must define the IP of the base used
for the data sync source.
Indicates the timeout to replace a base
station.
119