Remove The Handset Clip - Cisco IP DECT 6800Series User Manual

Handset Setup

Remove the Handset Clip

You can remove the clip from the back of the handset and replace it with a smooth cover that shipped with
your handset.
Before you begin
You need:
• #1 Phillips-head screwdriver
• Plastic cover to replace the belt clip on the handset. This cover is shipped to you in the product box.
Procedure
Step 1
Turn off the handset.
Step 2 Place the handset face down on a flat, level surface. You may want to place the handset on a large, clean cloth
to protect the handset.
Step 3 Use the screwdriver to remove the screws on the clip. Set the screws aside.
Note
Step 4
Lift up the loose end of the clip. The clip assembly should come off the handset.
Step 5
The replacement cover has a hook in the back. Slide the hook into the recessed area of the handset and press
it into the handset.
This diagram shows the hook on the back.
The screws are small, so be careful not to lose them.
Remove the Handset Clip
Cisco IP DECT 6800 Series User Guide
25