Cisco 6800 Series Administration Manual page 111

Monitoring
Table 17: DHCP Options Section Fields
Field
Plug-n-Play
Table 18: TCP Options Section Fields
Field
TCP Keep Alive Interval
Table 19: Discovery Section Fields
Field
LLDP-MED Send
LLDP-MED Send Delay
CDP Send
CDP Send Delay
Contents Description
Values: Indicates if the base automatically receives PBX IP
addresses under DHCP option 66.
• Disabled
• Enabled (default)
Contents Description
Integer Identifies the length of time, in seconds, that the client
waits before it sends a keep-alive message on a TCP
Range: 0–65535
connection.
Default: 75
Contents Description
Values: This field is new in Firmware Release 5.0.
• Enabled (default) Controls the use of Link Layer Discovery Protocol
(LLDP) on the base.
• Disabled
If enabled, the base station sends 5 LLDP-MED
messages after it starts.
Integer This field is new in Firmware Release 5.0.
Range: Identifies the length of time, in seconds, that the
device waits between LLDP-MED messages.
Default: 30
Note
Values: Controls the use of Cisco Discovery Protocol (CDP)
on the base. For more information about CDP, see
• Disabled (default)
Network Protocols, on page
• Enabled
Integer Identifies the length of time, in seconds, that the
device waits between CDP messages.
Range: 1–255
Default: 60
Cisco IP DECT 6800 Series Administration Guide
Network Web Page Fields
The option LLDP-MED must be enabled
to use this option.
179.
• Disabled—The base station doesn't send CDP
messages.
• Enabled—The base station sends CDP messages.
103