Specifications and Supplemental Performance Characteristics
Supplemental Performance Characteristics
This section provides useful data on the 16034G. These supplemental performance
characteristics should not be considered specifications.
Frequency Range
With OPEN/SHORT correction
With OPEN/SHORT/LOAD correction
Additional Errors (With OPEN/SHORT correction)
Additional errors are calculated as follows.
|Z| Measurement
Additional error Ze [%] of the |Z| measurement is calculated by substituting the
values in the table below into the following equation.
Ze[%] = ± {A + (Zs/Zx + Yo × Zx) × 100}
where
A [%]
Additional Error (Proportional Error)
Zs []
Short Repeatability (Impedance)
Yo [S]
Open Repeatability (Admittance)
Zx []
Measured Value (Impedance)
Zs
{10 + 13 × ( f / 10 )} × 10
Yo
{5 + 500 × ( f / 10 )} × 10
A
0.5 × ( f / 10 )
where f is frequency (MHz).
D Measurement
Additional error De of the D measurement is calculated by additional error Ze [%]
of |Z| measurement as follows.
If Dx 0.1:
De = Ze / 100
If 0.1 Dx 0.5:
De = ( Ze / 100) × (1 + Dx)
Chapter 3
Supplemental Performance Characteristics
3 MHz
120 MHz
-3
[]
-9
[S]
2
[%]
23