Lower Engine Cover - TOHATSU NB-1000 Service Manual

SECTION 5

LOWER ENGINE COVER

Removal
1. Remove powerhead as described in Section 4.
2. Remove control cables, electrical leads and grommets as
required from lower engine cover.
3. Remove lower engine cover bolts (4).
1
4. Lift cover off engine base.
8/9.8 Shift Rod and Throttle Removal
1. Remove spring pin (1) using special tool.
2
2. Remove throttle wire (2) and grommet (3).
3
9.9/15/18 Throttle Shaft Removal
4
1. Remove throttle shaft support (1).
4
2. Remove throttle shaft (2).
25/30/40 Throttle Shaft Removal
5
1. Remove throttle shaft ball joint (1).
5
2. Remove upper and lower throttle shaft supports (2).
5
3. Remove lower motor cover bolts (3).
4. Raise the cover slightly and remove the shift rod (4) from
5
the shift rod lever (5).
5. Remove the lower cover.
5
Installation
Installation is done in the reverse order of Removal. Use
6
Loctite 242 on throttle stopper bolt (1) if removed.
5-18
T1634 T1666
4
5
T1667
T1664
T1665
T1668
1-/ 2-Cylinder