X-Y Mode - Rigol MSO4000 Series User Manual

Chapter 3 Horizontal System Setting

X-Y Mode

In this mode, the X axis and Y axis both represents voltage. The oscilloscope
automatically turns on all the four channels (CH1 to CH4) and the screen is divided
into two cursor areas (XY1 and XY2). In XY1 area (at the left of the screen), the X
axis and Y axis track the voltages of CH1 and CH2 respectively; in XY2 area (at the
right of the screen), the X axis and Y axis track the voltages of CH3 and CH4
respectively.
The X-Y time base mode can be used to test the phase variation of a signal when it
passes through a circuit network. Connect the oscilloscope with the circuit and
monitor the input and output signals of the circuit.
Note:



MSO4000/DS4000 User's Guide
800.544.2843
In this mode, the "To Adjust the Horizontal Position", "To Turn Delayed
Sweep On/Off", "To Specify the Acquisition Mode", "Trigger", "To Make
Math Operation", "To Make One-key Measurement", "To Specify the
Measurement Range", "Logic Analyzer", "Protocol Decoding",
"Reference Waveform", "Pass/Fail Test", "Waveform Recording" and
"Vectors" are not available.
The "X-Y" cursor mode (refer to "X-Y Mode") is only available in this time base
mode.
If delayed sweep is currently turned on, when the "X-Y" mode is turned on, the
delayed sweep will be turned off automatically. When the "Y-T" mode is turned
on again, the delayed sweep will be turned on automatically.
www.calcert.com
15
10 20
5 25
0 30
RIGOL
3-5
sales@calcert.co