To Configure The Usb Interface; To Set The Gpib Address - Rigol MSO4000 Series User Manual

RIGOL

To Configure the USB Interface

This oscilloscope can communicate with PC or PictBridge printer via the USB DEVICE
interface at the rear panel. You need to set the oscilloscope to make it matchs with
different device types.
Press Utility  IO Setting  USB Device and turn the multi-function knob
select the desired device type.
Computer: in this mode, the oscilloscope can communicate with the PC.

PictBridge: in this mode, the oscilloscope can communicate with the PictBridge

printer.

To Set the GPIB Address

To control the oscilloscope using the GPIB bus, you need to extend a GPIB interface
for the oscilloscope using the USB-GPIB interface converter (option, need to be
ordered separately). Then, connect the oscilloscope with the PC using a GPIB cable.
Press Utility  IO Setting  GPIB and turn the multi-function knob
the desired GPIB address. The range available is from 1 to 30 and the default is 1.
14-8
800.544.2843 www.calcert.com
15
10 20
5 25
0 30
Chapter 14 System Function Setting
MSO4000/DS4000 User's Guide
sales@calcert.co
to
to select