To Select The Reference Waveform Source Channel; To Save And Display The Reference Waveform - Rigol MSO4000 Series User Manual

RIGOL

To Select the Reference Waveform Source Channel

1. Press REF  Current to select the specified reference waveform channel (Ref1
to Ref10) as the current reference waveform channel.
Press Source and turn the multi-function knob
2.
CH4, MATH or D0-D15) for the current reference waveform channel. You can
also press Source continuously to switch the source currently selected.
Note: Only channels (CH1 to CH4, MATH or D0-D15) that have been turned on
currently can be selected as the reference waveform source channel.

To Save and Display the Reference Waveform

Press REF  Current to select the specified reference waveform channel (Ref1
1.
to Ref10) as the current reference waveform channel.
Press Save; the oscilloscope will save the waveform (screen region) of the
2.
current reference waveform source channel to internal memory according to the
current setting and display it on the screen in the specified color and vertical
offset.
Note:
This operation only saves the reference waveform in the volatile memory and

the waveform will be cleared at power-off.
You can specify the reference waveform source channel by referring to "To

Select the Reference Waveform Source Channel".
You can specify the reference waveform color by referring to "To Set the

Reference Waveform Color".
You can adjust the vertical position and vertical scale of the reference waveform

by referring to "To Adjust the Reference Waveform Display".
After performing the "Save" operation, you can still set the reference waveform

color and adjust the display of the reference waveform (vertical position and
vertical scale).
9-4
800.544.2843 www.calcert.com
15
10 20
5 25
0 30
Chapter 9 Reference Waveform
to specify a source (CH1 to
MSO4000/DS4000 User's Guide
sales@calcert.co