Spi Decoding (Option) - Rigol MSO4000 Series User Manual

RIGOL

SPI Decoding (Option)

The SPI serial bus is based on the master-slave configuration and usually consists of
the chip select line (SS), clock line (SCLK) and data lines. Wherein, the data lines
include the master input/slave output data line (MISO) and master output/slave
input (MOSI) data line. The oscilloscope samples the channel data on the rising edge
or falling edge of the clock signal (if the source is an analog channel, the oscilloscope
will alos judge each data point (logic "1" or logic "0") according to the preset
threshold level.
Press Decode1  Decode, turn the multi-function knob
press the knob. You can also press Decode continuously to switch to "SPI".
Set the SPI decoding (take Decode1 as an example):
1. Turn on or off the Decode1
Press BusStatus to turn the Decode1 display on or off. You can also press
Decode1 to switch the current on/off status of the Decode1 display. When the
bus display is turned on, the interface is as shown in Figure 8-5.
2. Quickly apply the current SPI trigger setting to SPI decoding
If the current trigger type of the trigger system is SPI, press CopyTrig to copy
the current SPI trigger settings and apply them to the SPI decoding function (set
the corresponding SPI decoding parameters automatically). The settings that
can be copied include the CS/timeout mode, clock channel, data channel and
data bits.
For the CS mode, the CS channel (CS) and level polarity (Mode) in the

trigger setting will be copied to the CS channel (SS  Channel) and
polarity (SS  Polarity). If the CS channel in the trigger setting is an
analog channel, the threshold level setting will also be copied.
For the timeout mode, the timeout time setting will be copied.

If the clock channel is an analog channel, the threshold level setting will be

copied.
For the data channel, the data channel (SDA) in the trigger setting will be

copied to the MISO source channel (MISO  Channel) in the decoding
8-20
800.544.2843 www.calcert.com
15
10 20
5 25
0 30
Chapter 8 Protocol Decoding
to select "SPI" and
MSO4000/DS4000 User's Guide
sales@calcert.co