Rigol MSO4000 Series User Manual page 293

Chapter 11 Waveform Recording
3. Set the start frame
4. Set the end frame
5. Execute the playback operation
1) Start the playback operation
MSO4000/DS4000 User's Guide
800.544.2843
Press Start Frame and turn the multi-function knob
of playback. The maximum range is from 1 to the number of frames recorded.
The default is 1.
Note: The actual range of the start frame is from 1 to the end frame currently
set (End Frame).
Press End Frame and turn the multi-function knob
playback. The maximum range is from 1 to the number of frames recorded. The
default is the number of frames recorded.
Note:
The actual range of the end frame is from the start frame currently set

(Start Frame) to the number of frames recorded.
Please distinguish the end frame here from the end frame in the waveform

"Record" mode.
After setting the desired playback parameters, you can press the menu key or
the front panel shortcut key to start or stop the playback operation.
Note: Please set the playback parameters above before starting the playback
operation. You cannot set the playback parameters after the playback operation
starts.
Press Operate, turn the multi-function knob
the knob or directly press the playback/pause shortcut key (
panel; the oscilloscope starts the playback according to the current settings.
During the playback process, the backlight of the playback/pause shortcut
key ( ) is illuminated in yellow and flashes continuously. The number of
frame currently played back is displayed in the playback information at the
upper-right side of the screen and in Current Frame.
www.calcert.com
15
10 20
5 25
0 30
RIGOL
to set the start frame
to set the end frame of
to select " " and press
) at the front
sales@calcert.co
11-9